Table of Contents
Advertisement
Error Message
Insufficient USB
Storage
No Access Point
No Certificate
No PC found
No Profile found
(ADS-3300W)
Not Registered
Remove documents.
Replace Pickup Roller
Scheduled Maintenance
Alert
Sending Error
(ADS-3300W)
Cause
The inserted USB flash drive is full.
The machine cannot detect a wireless
access point/router that has an active
WPS function.
The certificate does not exist, or is
corrupted.
The machine is not connected to your
computer.
No Scan to FTP/SFTP profile or Scan to
Network profile is registered.
(Scan)
You tried to access an email address that
has not been registered in the address
book.
(Secure Function Lock)
A user not registered in Secure Function
Lock is accessing the machine.
Auto Start Scan Mode was enabled
while a document was loaded.
(ADS-3300W) All Rollers have been used
over 100,000 times.
The Pick Up Roller has been used over
5,000 times.
The Scan to FTP/SFTP profile, Scan to
Network profile or Scan to Email Server is
not configured correctly.
Action
See Related Information: Use Secure
Function Lock 3.0.
Press Close, and then do one of the
following:
•
Delete unused files or folders from the
USB flash drive, and then try again.
•
Use a USB flash drive that has more
free space.
Check the following:
•
You did not press the WPS button on
two or more wireless access point/
routers.
•
Restart the machine and the wireless
access point/router.
Configure the settings under Signed PDF
in the Administrator menu in Web Based
Management.
Connect the machine to your computer,
and then try again. If a USB flash drive is
inserted into the machine, remove it.
Configure the Scan to FTP/SFTP profile
or the Scan to Network profile before
using Scan to FTP/SFTP or Scan to
Network.
See Related Information: Set up a Scan to
FTP Profile.
See Related Information: Set up a Scan to
SFTP Profile.
See Related Information: Set up a Scan to
Network Profile.
Make sure the email address is correctly
configured.
Contact your administrator to check your
Secure Function Lock settings.
See Related Information: Use Secure
Function Lock 3.0.
Remove the document, and then reload it.
Replace all rollers with new ones.
Scanning errors may occur if you do not
replace the part.
See Related Information: Replace the
Roller Kit.
Clean the Brake Roller and Pick Up
Roller. Paper jams and reduced scan
quality issues may occur if you do not
clean them.
See Related Information: Clean the
Scanner and Rollers.
Make sure the Scan to FTP/SFTP profile,
Scan to Network profile or Scan to Email
Server is configured correctly.
179
Advertisement
Table of Contents
