❷ Projecting Images Stored In A Usb Memory Device (Basic Operation) - NEC NP43 User Manual

❷ Projecting images stored in a USB memory device (Basic operation)
This section explains the basic operation of the Viewer.
The explanation provides the operational procedure when the Viewer [OPTIONS] menu (→ page 45) is set to the
factory default.
- Starting the Viewer ......................................................................below
- Removing the USB memory from the projector ......................
- Exiting the Viewer ....................................................................
Preparation: Before starting the Viewer, store images to the USB memory using your computer.
Starting the Viewer
1. Turn on the projector. (→ page 16)
2. Insert the USB memory into the USB port of the pro-
jector.
- To remove the USB memory from the projector, select
"REMOVE USB DEVICE" from the OPTIONS menu. (→
Step 5 on page 43)
3. Press the ▶ (SOURCE) button.
The SOURCE list will be displayed.
• Another way to display the SOURCE list is to press the
VIEWER button on the remote control. Go on to Step [5].
4. Press the ▶ (SOURCE) three times to select the cur-
sor to [VIEWER].
Each time the ▶ button is pressed quickly, the next
source will be highlighted.
• During this time, do not press and hold the ▶ button for
2 seconds or longer. Doing so will start the projector to
detect the signal automatically.
Highlighting [VIEWER] for a while will start the Viewer to
project images stored in the USB memory (slide screen).
5. Using the Viewer (NP64/NP54)
page 42
page 43
41