Electrical Requirement & Connections; Water Connection For Your Ice Maker - NewAir NCI080SS00 Owner's Manual

EN
ELECTRICAL REQUIREMENT & CONNECTIONS
WARNING: THIS UNIT MUST BE GROUNDED
ELECTRICAL SHOCK HAZARD
• Plug into a grounded wall outlet.
• Never remove the ground prong.
• Use separate power supply or receptacle. Never use an adapter.
• Never use an extension cord.
• Failure to follow these instructions can result in death, fire, or electrical
shock.
Before you move your ice maker to its final location, it is important to make
sure you have the proper electrical connection.
It is recommended that a separate circuit, serving only your ice maker, be
chosen. Only use outlets that cannot be operated by a switch or pull chain. If
the supply cord or plug needs to be replaced, it should be done by a qualified
service engineer.
This appliance requires a standard 110-120Volt, 60Hz grounded electrical
outlet.
RECOMMENDED GROUNDING METHOD
For your personal safety, this appliance must be properly grounded. This
appliance is equipped with a power supply cord with a grounding plug. To
minimize possible shock hazard, the cord must be plugged into a corresponding
grounding wall outlet, grounded in accordance with the National Electrical
Code and local codes and ordinances. If a mating wall outlet is not available, it
is the personal responsibility of the customer to have a properly grounding wall
receptacle installed by a qualified electrician.

WATER CONNECTION FOR YOUR ICE MAKER

Important: Be sure to use the new hose sets supplied with the appliance to
connect to water mains. Old hose sets should not be reused.
1. Connect the water supply hose to the unit
First, remove the tape on the water inlet port (indicated in the following
illustration as "B") located at the back of the unit, then use your finger to press
and remove the plastic circular cover ("A"). Next, insert one end of the white
www.newair.com
19