Steps For Cleaning The Ice-Making Parts - NewAir NCI080SS00 Owner's Manual

WARNING: DO NOT use solvent cleaning agents or abrasives on the interior.
These cleaners may transmit taste to the ice cubes or damage or discolor the
interior.

STEPS FOR CLEANING THE ICE-MAKING PARTS

During use, periodically clean the main system of your ice maker. Read the
detailed instructions or visit this link to the Newair Support Center for more
information on how to clean your ice maker:
https://newairsupport.zendesk.com/hc/en-us/articles/12294930453780-
Cleaning-Your-Ice-Maker
1. Repeat the above steps to clean the water tank and other inner parts of
the unit.
2. Pay special attention to the water-dividing pipe on the evaporator. When
the compressor and water pump are running normally, water should flow
out through the water-dividing pipe. If there is no water flowing out from
the pipe, or if the flow is very minimal, please remove the water-dividing
pipe to clean carefully. Clean each small hole on the water-dividing pipe as
displayed in the following illustration. Ensure none of the holes are
clogged, then install back to its original location.
www.newair.com
EN
27