Hitachi C 10FSH Instruction Manual page 14

English
8mm Depth
Adjustment Bolt
Loosen
Gear Case
Fig. 10
3. Lower limit position of saw blade when cutting a large workpiece
NOTE:
When cutting a workpiece exceeding 3-11/32" (85mm) in height in right-angle cutting or 2-3/
16"(55mm) in left bevel angle cutting or 1-3/16" (30mm) in right bevel angle cutting, adjust
the lower limit position so that the base of the motor head (see Fig. 9) will not come in
contact with the workpiece.
To adjust the lower limit position of the saw blade, follow the procedures (1) to (3) shown in Fig. 10-a.
(1) Loosen the 8mm wing nut so that the 8mm depth adjustment bolt can be turned by hand.
(2) Lower the motor head, and thru the 8mm depth adjustment bolt by hand and make adjustments so
that there can be a clearance of 3/32" to 1/8" (2mm to 3mm) between the lower limit position of the
motor head and the top of the workpiece at the saw blade's lower limit position (where the head of
the 8mm depth adjustment bolt contacts the gear case.
(3) After adjustment, turn the 8mm wing nut until it contacts the Hinge (see Fig. 10), and fully tighten it.
4. Confirmation for use of sub fence
WARNING:
Left bevel angle cutting
Turn
Sub Fence
Fence (B)
Fig. 11
14
(4) Turn the 8mm hexagon socket set screw to the right (clockwise)
8mm Hexagon Socket
Set Screw
Turn
Hinge
8mm Wing Nut
In the case of left bevel cutting, turn the sub fence counterclockwise. Unless it is
turned counterclockwise, the main body or saw blade may contact the sub fence,
resulting in an injury.
This power tool is Equipped with a sub fence.
Right bevel angle cutting
Direct angle cutting
In the case of direct angle cutting and right bevel angle cutting, use
the sub fence. Then, you can realize stable cutting of the material
with a wide back face.
In the case of left bevel cutting, raise the sub fence up as illustrated
in Fig. 11 and then turn it counterclockwise.
as viewed from behind of the tool, and let it softly contact the
tip of the 8mm depth adjustment bolt.