Xplore Hub 5 Router Using Wps - Xplore Whole Home Wi-Fi User Manual

Xplore Hub 5 Router using WPS

If you do not have a Whole Home Wi-Fi network, you can skip this
step.
If you already have Xplore Whole Home Wi-Fi Unit(s) that are
1
in use, you will need to perform a factory reset first using the
button on the back (Hold for 10 seconds), wait 3 mins for it to
power on fully. Repeat for all units.
Plug the first new or existing Whole Home Wi-Fi Unit (agent)
2
into a power outlet where you would like it installed. Wait 3
minutes for it to start up. LED Light at the front of the agent
Whole Home Wi-Fi Unit would be solid Red while unit is
booting up.
Press the WPS button on the back of the Hub 5 unit, and then
3
the blue WPS button on the front of the agent Whole Home
Wi-Fi unit. The light on the agent unit will turn blue, once it has
synchronized.
If it does not turn solid blue but rather flashing blue instead,
4
then the unit may need to be placed closer to the controller
unit.
Repeat for the other agent Whole Home Wi-Fi Units if
5
applicable. If the agent Wi-Fi unit LED light flashes in Red, this
indicates failure to sync with the Hub. Repeat steps 1-5 again.
X P L O R E W H O L E H O M E W I - F I
Xplore
Hub 5
Modems may vary
in appearance
Modem
U S E R G U I D E
Whole Home
Wi-Fi Unit
7