Zamboni FastICE Training Manual page 17

6. Adjust ice water spray scaling factor to set the target ice thickness
6.a. Adjust desired spray thickness according to ice conditions.
7. Recommended resurfacing speed
7.a. We recommended a speed for FastICE Sessions of 5 MPH (8 km/h). This speed
should be maintained throughout the ice resurfacing session, both in the straights
and in the turns.
8. Turn Upper spray boom OFF in the crease area
8.a. We recommended turning off the Upper boom OFF in the goal crease area, and
behind the goal line, as this will avoid putting too much water in these areas.
8.b. We recommend experimenting with the system to determine which boom you
prefer to turn off while going through these areas.
8.c. Note that there is an automatic setting within the SETUP screen that allows you to
select which boom is turned off once your speed drops below a certain value. This
feature can be helpful to operators who prefer to drive more slowly in the crease
and behind the goal line, and to have the boom shutoff process be automatic.
9. Turn the Upper and Lower spray boom switches off
9.a. Turn the FastICE spray booms off once the ice resurfacing session is complete.
10. Drain Ice Making Water Tank
10.a. Drain the Ice Making Water tank at the end of the ice resurfacing session. We
recommend that the tank be filled only to what will be used during the resurfacing
session to guarantee that only hot water is used to make ice.
Zamboni FastICE ® Training Manual
DK - 11001
Training Manual
Page 17 of 20