Wall Installation (With Fixing Bracket) - Panasonic WX-CR480P Operating Instructions Manual

■ Wall installation (with fixing bracket)

Unplug all cables from the repeater and follow these installation procedures.
● When installing the repeater on a wall, place it higher than 1.5 m (59-
Important 1/16 inches) from the floor. Placing the repeater at a low place could
reduce the range it can cover. In particular, people, metal products, and
pieces of furniture placed between the repeater and the center module
may block the radio waves interfering with the transmission, resulting in
audio dropouts.
1
Screw the fixing bracket to the wall
Fix the fixing bracket to the wall with the four included wood screws (4.1 mm x 25 mm
(3/16 inches x 1 inches)).
Pay attention to the direction into which the arrow ( ) is pointing relative to the fixing
bracket. The arrow ( ) reflects where the top of the repeater will point.
Fixing bracket
(included)
● The minimum pullout strength required for each wood screw is
Important
● Do not install the repeater on gypsum boards, plywood, or walls
● For fixing the bracket, only use the screws included with the
WX-CR480P_PUQX1029ZAV1_OI_en-fr.indb
Mind the direction
196 N.
made of other fragile materials. If you absolutely must do so, make
sure that the wall is reinforced enough.
repeater. Not doing so may cause the repeater to fall.
21
Wood screws
(included)
2021/11/08
21
13:25:15