Grundfos SE 12-42 hp Service Instructions Manual page 7

Installation types S, C and D
Always handle the pump by means of the correct
lifting points.
When lifting the pump, use the right lifting points to keep the
pump balanced. SE, SL pumps installation types S, C and D are
equipped with two lifting point which ensure that the pump can be
lifted in a safe manner. See fig.
correct lifting point.
Middle
Front
Lifting points, installation types S, C and D
Fig. 7
Outlet flange size
NPS 3" (DN 80)
NPS 4" (DN 100)
NPS 6" (DN 150)
NPS 8" (DN 200)
NPS 10" (DN 250)
NPS 12" (DN 300)
Installation type H
Installation type H can be lifted by a hole in the flange and the
front lifting point. See fig. 8.
Lifting points, installation type H
Fig. 8
7 and the table below to find the
lifting point
Middle
Front
3.2.3 Raising the pump to upright position
1. Fasten the lifting equipment as shown in the figure below.
Lifting the pump
Fig. 9
2. Lift at the top end of the pump as shown in the figure below.
Fig. 10 Lifting the pump
Fig. 11 Pump correctly raised to upright position
3.2.4 Storing the product
See the installation and operating instructions for SE, SL 12-42
Hp (9-30 kW). Use the QR code and link on the front page of this
document.
7