Table of Contents
Advertisement
DUST COLLECTION
1. Attach a 2½" dust hose (not included) to the dust port
(Fig. 13 - 1).
2. Secure the hose with a hose clamp (not included). Make
sure the hose is attached to the dust port tightly.
CAUTION: Always use dust collection when operating the
machine. It's safer, less messy, gives better cuts, and helps
prolong your machine's life. Failure to use dust collection
may void your warranty.
SWITCH ASSEMBLY
This machine is equipped with a magnetic switch to prevent
the saw from being damaged by overload. It also includes a
red paddle for quick emergency stops, if necessary. Finally,
a flip-down tab is provided to prevent unauthorized access
to the green ON button 14). Slide a padlock through the
sides of the switch housing and the flip-down tab for maxi-
mum protection.
CHANGING THE BLADE DEPTH
Loosen the center locking knob, then turn the handwheel
clockwise to raise the blade, or counterclockwise to lower
the blade. Once the blade is at the desired height, tighten
the center locking knob to lock it in place (Fig. 15).
16
ASSEMBLY
OPERATION
Flip-Down
Tab
Green ON
Button
Red OFF
Button
(Below Red Paddle)
Height
Adjustment
Wheel
Fig. 13
1
Fig. 14
Fig. 15
Locking
Knob
Advertisement
Table of Contents
