Table of Contents
Advertisement
13.
Install the filler bolt and washer to the filler port
of the reduction case and tighten the filler bolt
(Figure
62).
14.
Install the engine; refer to
(page
38).
Installing the Engine
Belt Maintenance
Inspecting the Belts
Service Interval: After the first 25 hours—Inspect
the belts and adjust as necessary
(belt-drive models only).
Every 40 hours—Inspect the belts and adjust as
necessary (belt-drive models only).
1.
Park the machine on a level surface and shut
off the engine.
2.
Allow the machine to cool.
3.
Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page
4.
Remove the divider plate; refer to
Divider Plate (page
5.
Move the clutch lever to the O
6.
Examine the belts for wear or damage. If the
belts are worn or damaged, replace them; refer
to
Replacing the Belts (page
7.
Examine the pulleys for wear, damage, and
misalignment; refer to
45).
8.
Install the divider plate; refer to
Divider Plate (page
Adjusting the Belt Tension
Clutch air gap: 2.5 to 6.5 mm (3/32 to 1/4 inch)
1.
Park the machine on a level surface and shut
off the engine.
2.
Allow the machine to cool.
3.
Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page
4.
Move the clutch lever to the O
5.
Measure the air gap between the engine deck
and the roller on the clutch
42
28).
Removing the
28).
position.
FF
44).
Aligning the Pulleys (page
Installing the
28).
28).
position.
N
(Figure
64).
Advertisement
Table of Contents
