Connection - Conrad Electronic ViewCam VC-1026B Operating Instructions Manual

Find a suitable mounting locati-
on from which the target object
can be monitored.
The recommended mounting
height of the camera lens (1) is
approx. 1.8 m.
The microphone (2) is beneath
the camera.
Use the drilling holes (13) in the
base plate of the camera mo-
unting kit to mark the positions
of the fixing holes.
Remove the base plate again
and drill the fixing holes.
Select one of the two supplied
support bases on which the ca-
mera is to be mounted.
Insert the support base (11 or
12) through the base plate mo-
unting hole (14) and screw the
base plate to the wall with sui-
table screws.
Press the camera opening (3)
on the rear of the camera onto
the support base (11 or 12).
10
Note
This should lie within 15 metres
so that the camera can still be
connected with the TV receiver.
Note
The mounting height depends
on the object to be monitored.
Take care that no electric ca-
bles, water pipes, etc. are pre-
sent under the proposed dril-
ling positions.
Note
(11) for inclined mounting,
(12) for level mounting.
Note
If required, use suitable wall
plugs.
Note
The support base will latch au-
dibly into the camera.

Connection:

Ensure that the in-plug power supply plug is not
plugged into a power socket while making connec-
tions.
• Insert the DIN plug (4) into the connection adapter DIN socket
(5).
• Connect the yellow connection adapter phono plug (6) to the
video input of the TV receiver.
• Connect the white connection adapter phono plug (7) to the
audio input of the TV receiver.
• Now insert the low voltage plug (10) into the connection adap-
ter socket (8).
TV receiver
(yellow)
Video In
Audio In
(white)
11