Plantronics Voyager Legend CS Quick Start Guide

Overview

Answer a call, choose:

• Put on the headset to answer call, or
• Tap the Call button or
• Say "answer" after call is announced. (Available only with your mobile phone)

End a call

Tap the Call button to end current call.

Voice dial (mobile phone feature)

Press the Call button for 2 seconds, wait for phone prompt and then tell the phone to dial the name of a stored contact.

Mute the microphone during a call

Tap the Mute button . You will hear "mute on" confirmation. An alert is repeated every 15 minutes as a reminder. Tap the Mute button again to open the microphone and hear "mute off" confirmation.

Adjust the volume

Toggle the Volume button up (+) or down (–) during a call or while streaming audio.

1. Call status

• Idle = unlit
• Incoming call = fast blue flash
• On call = solid blue
• Call (headset mic) muted = slow blue flash

2. Power LED

• Power off = unlit
• Powered = solid blue
• In pairing mode = red/blue flashing
• Pairing successful = solid blue

3. Headset battery LED (when docked)

• Full battery, charging stopped = solid blue
• High, charging = 3 blue flashes every 10 seconds
• Medium, charging = 2 blue flashes every 10 seconds
• Low, charging = 2 red flashes every10 seconds
• Critical, charging = 3 red flashes every 10 seconds

Charge, connect and call from desk phone

Charge your headset

1. Plug one end of power supply into power jack on back of the base and other end into working power outlet.
   

2. To charge, dock headset in base for minimum of 20 minutes.
   

Connect desk phone

Connect cables from desk phone to base.

Make desk phone call

1. While wearing headset, press Call button.
   

2. Remove the desk phone handset.
   NOTE For remote call control capability (HL10 lifter or EHS cable),see plantronics.com/accessories.
3. Dial test call from desk phone.
4. End call by pressing headset Call button and hang up the handset. Troubleshooting Tip: If you do not hear a dial tone, adjust the slide switch (A–G) until you do. Default setting A works for majority of desk phones.
   

Pair mobile phone and call

Pair your mobile phone

1. Power on your headset then choose:

• Tap the Voice button and say "Pair mode", or
• Press and hold the Call button until you hear "Pairing."

2. While the headset LEDs are flashing red and blue, activate Bluetooth® on your phone and set it to search for new devices.
3. Select "PLT_Legend."
   

4. If prompted by your mobile phone for a passcode enter 0000. Once successfully paired, LEDs stop flashing red and blue and you hear "pairing successful." Some phones may prompt you to allow access to contacts to enable caller name announcement.
   

5. Make a test call from your mobile phone.
6. End the call by pressing the call button . The call does not end when you remove your headset.

Pair another phone

After pairing your headset to your phone you may want to pair another or new phone.

1. Power on your headset then choose:

• Tap the Voice button and say "Pair mode", or
• Press and hold the Call button until you hear "Pairing"

2. While the headset LEDs are flashing red and blue, activate Bluetooth® on your phone and set it to search for new devices.
3. Select "PLT_Legend."
4. Once successfully paired, LEDs stop flashing red and blue and you hear "pairing successful."
   NOTE Some phones may prompt you to allow access to contacts to enable caller name announcement.

Answering a desk phone call while on a mobile call

Tap the Call button once to end the mobile phone call then press again to answer your desk phone call.
NOTE Use the same procedure when answering a mobile call while on a desk phone call.

Fit headset and charge with USB cable

Fit your headset

Replace the ear tip for a better fit.

1. Push in ear tip and rotate to the left to unlock it.
2. Align new ear tip into slot.
3. Push in ear tip and rotate to the right to lock it into place.

To wear the headset on your other ear, rotate the boom upwards then twist it around so ear tip is on other side before lowering boom.

Optional charging accessories

For more charging options go to plantronics.com/accessories and look for:

• Voyager Legend Charge Case
• Voyager Legend Desktop Charge Stand
• Voyager Legend USB Car Charger
• Voyager Legend Charge Cable

Use and Reset Smart Sensors

Use sensors

Smart sensors react when you put on or take off your headset. Putting on your headset will:

• Answer an incoming call
• Transfer an active call from your phone (available only with your mobile phone)
• Resume streaming audio

Taking off your headset will:

• Transfer an active call to your phone handset (available only with your mobile phone)
• Pause streaming audio
• Lock the Call button to prevent accidental calls

Try voice commands

Tap the Voice button wait for command request, then say a command. For example, "What can I say?" tells you the full list of available commands.

Reset sensors

You may need to reset the sensors if they are not working as expected. Wearing the headset, tap the Call button to test sensors:

• Talk time voice alert means sensors are working
• A tone means sensors need to be reset

To reset the sensors, charge your headset and place on a flat nonmetallic surface for more than 10 seconds.

Please refer to the separate safety instructions for important product safety information prior to installation or use.
The Voyager Legend CS headset system consists of a CSEB-01 headset base and a Voyager Legend Bluetooth headset.

NEED MORE HELP?

Technical support
www.plantronics.com/tco
Plantronics BV
South Point Building C
Scorpius 140
2132 LR Hoofddorp
Netherlands

This product is TCO certified, for more information visit www.plantronics.com/tco

© 2013 Plantronics, Inc. All rights reserved. Plantronics, and Voyager Legend are trademarks or registered trademarks of Plantronics, Inc. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Plantronics, Inc. is under license. All other trademarks are the property of their respective owners.

Patents: US 8,208,673; D617,316; D681,003; 681,014; D681,002; D662,089; BR 3020120011493; CN ZL201230489876.9; ZL201230059196.3; EM 002109637-0001; 002109637-0002; 0021096370003; 001315261-0001; IN 243252; TW D151481; Patents Pending.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Plantronics Voyager Legend CS Quick Start Guide