GE PFD95 Owner's Manual & Installation Instructions page 28

EXHAUSTING THE DRYER (cont.)
SIDE VENTING
WARNING
Disconnect dryer from electrical supply.
Wear gloves and arm guards.
Close the back opening with the access
panel included in kit GFA28DSVN.
Failure to do so may result in fire, electrical
shock or lacerations.
• Remove the 4 screws that secure the access panel
and save. Remove the access panel.
Remove
4 screws
and save
• Detach and remove the right or left side knockout
as desired. Remove the screw that secures the
dryer exhaust duct and save. Pull the exhaust duct
out of the dryer.
Right
knockout
Exhaust Duct
Remove screw and save
• Locate the 12-1/2" (31.5 cm) exhaust duct and
elbow duct from the kit and assemble together.
Apply duct tape around the joint to eliminate leaks
between ducts.
12-1/2" (31.5 cm)
28
Installation Instructions
- Fire Hazard
Access Panel
Left Knockout
SIDE VENTING (cont.)
• Insert and connect the elbow/exhaust duct assembly
to the blower housing and orient the elbow for either
left or right venting.
Left Venting
Right Venting
• Locate the bracket from the kit.
• Remove the adhesive liner from the bottom of the
bracket and position it behind the elbow duct tab.
• Press down firmly to secure the bracket to the bottom
of the dryer.
• Using one of the screws from earlier, secure the
elbow duct tab to the bracket.
Elbow Duct Tab
Bracket
Saved Screw
49-3000206 Rev 5