Table of Contents
Advertisement
Repair
NOTE: Repair kits are available (purchase separately).
See Kits and Accessories, page 20.
Prepare Equipment for Repair
Servicing this equipment may cause injury from
pressurized fluid if work is not properly performed.
•
Do not service this equipment unless you are
trained and qualified.
•
To reduce risk of injury, follow the Pressure
Relief Procedure before checking, servicing, or
repairing the equipment.
Always complete the following procedure before
performing any service or repair to the equipment.
1. Follow Pressure Relief Procedure, page 9.
2. Follow Flushing and Storage, page 11.
3. Verify that the equipment is turned off and power to
the system is disconnected before performing any
service or repair procedure.
4. Disconnect all air and fluid lines.
Replace the Spray Tip
To avoid injury from pressurized fluid, do not put your
hand in front of the spray tip when installing,
removing, or adjusting the spray tip.
3A8816A
Disassemble the Spray Tip
1. Follow the Pressure Relief Procedure, page 9.
2. Close all air valves.
3. Unscrew the tip retainer (23).
4. Disassemble the gasket (21) and spray tip (22).
5. Clean and inspect parts for wear or damage.
Replace parts as necessary.
Reassemble the Spray Tip
6. Install the spray tip (22) and gasket (21) inside the
tip retainer (23).
7. Securely tighten the tip retainer (23) to the housing
(9). See F
. 8.
IG
NOTE: The spray tip position determines the direction
and pattern width. To adjust the pattern, see Adjust the
Spray Pattern, page 8.
21
22
23
F
. 8
IG
Repair
9
20
15
Advertisement
Table of Contents
