Operation And Maintenance - NEC N8154-25 User Manual

Operation and Maintenance

Service representatives subordinate to or authorized by NEC provide services of the cage with use of
genuine parts and high technical capabilities. You can get the services for your own convenience.
For the services, contact the NEC sales department or representatives.
Removing or Replacing N8154-25
Remove or replace the cage in the following procedure:
1.
Turn off the power of the server and disconnect the power cables from the receptacles.
2.
Remove all the hard disk drives installed in the cage.
Before removing hard disk drives , note the installation order of the hard
disk drives.
Notice
3.
Remove the side cover on the server. Open the front door, remove the four screws fixing the cage
4.
Disconnect all the cables from the cage, and pull out it toward you from the server slowly.
Take care not to touch the left and right guide rails inside the cage.
5.
To replace the cage with new one, perform in "Step 2 Installing N8154-25 in Server", and install the
removed hard disk drives into the original slots.
6.
Install the removed side cover on the server as it was.
CAUTION
14