Roland TrueVIS SG3-540 Setup Manual page 27

1. Assembly and Ink Filling
4. Attach the cable clamps and the cable.
Procedure
1.
Attach seven cable clamps to the positions shown in the figure.
The two clamps on the side of the machine are used for the power cord and the Ethernet cable
and will be used later.
2.
Connect the control box cable to the [TAKE UP] connector on the unit.
• Pass the cable along the inside of the arm.
• Use a number 1 Phillips screwdriver to tighten the connector screws.
3.
Secure the cable with five cable clamps.
26
Installation