Roland TrueVIS SG3-540 Setup Manual page 23

1. Assembly and Ink Filling
2. Attach the control box and the left stay.
Procedure
1.
Place the control box (A) on the right stand leg.
Assemble the motorized media holder (B) by passing it through the rear of the right stand leg.
Place the holder outside the printer.
IMPORTANT
The control box (A) and the motorized media holder (B) are connected with a wire. Do not subject this wire to
excessive force.
2.
Temporarily tighten the four bolts shown in the figure.
3.
By hand, tighten the temporarily tightened bolts until there is no gap between the left arm and the
stand.
Hold the pieces together so there is no gap between the outside surface of the stand leg and the
control box stay when tightening the bolts.
4.
Make sure the protrusion on the stand leg (A) is in the center of the hole on the control box stay (B).
Move the control box until this protrusion is centered.
22
Installation