26
5 HANDLE AND CONTROL SYSTEM
(B)
(A)
5-1 Adjusting handle position
5-2 Removing handle
(A)
8K029A
HANDLE AND CONTROL SYSTEM
(D)
(C)
(F)
(E)
(A)
( A ) Throttle control lever
( B ) Front handle
( C ) Throttle control trigger
( D ) Ignition switch
( E ) Throttle wire
( F ) Handle bracket
1. Loosen knob (A) until the handle can move.
2. Adjust the handle to suitable position and angle.
3. Fasten knob (A).
NOTE: When replacing throttle control or ignition
switch, the handle should be removed in advance.
1. Remove knob and nuts.
2. Loosen bolt (A) at the bottom of handle bracket
1 to 2 turns.
3. Remove handle from the bracket.
PB-650
PB-750