Baby At Mainbard - Pine Technology TL-BX31 User Manual

2.4.2 Baby AT Mainboard
CPU FAN connector (P4)
Plug in the fan cable to the 3-pin fan connector onboard. The fan connector is marked CPU
FAN and FAN on the system board.
Pin1
Pin2
Pin3
Flash ROM Voltage Selector (J25)
Pin
1-2
2-3
Note : The factory default is 1-2, it is not recommended to change the factory default setting.
ATX Soft-Power Switch Connector (P2)
The ATX soft-power switch connector is a 2 pin header on the system board. Locate the
power switch cable from your ATX housing. Plug this connector to the soft-power switch
connector marked P2 PWRBT.
P2
Post ON
Post OFF
Sense
+12V
GND
Description
12v (default)
5v
PWERBT function
Instant ON/OFF
Delay 4 second
INTEL PII
User's Guide
20