Table of Contents
Advertisement
2.3
HOW TO SET JUMPER
Jumper switch is used to select between various operating modes. A jumper switch consists of
two or three gold pins, which stretches out from the system board. By using the cap to cover two
pins is to short those pins. If the cap is not placed on any pins at all, it indicates to leave the pins
open.
To set a jumper switch, please refer to below :
¨ to close a jumper, insert the plastic jumper cap over two pins of a jumper
¨ to open a jumper, remove the jumper cap
The following conventions are used to represent the proper jumper settings :
3
1
3
1
When you open a jumper, attach the plastic jumper cap to one of the pins so you
NOTE :
won't lose it.
2.4 JUMPERS & CONNECTORS
Setting the CPU Voltage
This mainboard supports Pentium II VID function, the CPU core voltage is automatically
detected, the range is from 1.3V to 3.5V.
Pentium II VID signal provides CPU voltage auto-detection, therefore, no worries on
wrong CPU voltage select.
3
1
3
1
User's Guide
OPEN
CLOSED (2-3 position)
INTEL PII
14
Advertisement
Table of Contents
