Advertisement
Quick Links
WE-EF LEUCHTEN
Installation and Maintenance
Instructions
Pole Mounted Luminaire
ZFT400
ZAT400
Do not open during installation
This product is factory-sealed.
Refer to the instructions contained in this
document for details.
Surge Protection
This product features built-in surge protection circuitry in compliance with
applicable standards.
For comprehensive protection of a luminaire installation against lightning and
electrical surges, it is essential to cover mains supply and data input lines at
the distribution board level, by using respective primary (Type 1) and secondary
(Type 2) surge arrestors in compliance with EN61643-11/IEC61643-1.
Warning
Ensure that all required surge protection measures are in place and activated
prior to luminaire installation. Also, disconnect luminaires before operating
high-power devices such as, for example, electrical arc welders.
Advertisement
Related Manuals for WE-EF ZAT400 Series
Summary of Contents for WE-EF ZAT400 Series
- Page 1 WE-EF LEUCHTEN Installation and Maintenance Instructions Pole Mounted Luminaire ZFT400 ZAT400 Do not open during installation This product is factory-sealed. Refer to the instructions contained in this document for details. Surge Protection This product features built-in surge protection circuitry in compliance with applicable standards.
- Page 2 Pole Mounted Luminaire ZFT430-FT ZFT460-FT ø 170 ø 250 ZFT434 ZFT464 ø 76 x 80 ø 76 x 80 ZFT440-FT ZFT470-FT ø 170 ø 250 ZFT444 ZFT474 ø 76 x 80 ø 76 x 80 IP66. IK08/IK09. Class I. ta = 25°C Weight Tools required for ZFT430-FT/434...
- Page 3 ZAT430-FT ZAT460-FT ZAT434 ZAT464 ZAT440-FT ZAT470-FT ZAT444 ZAT474 IP66. IK08/IK09. Class I. ta = 25°C Weight Tools required for ZAT430-FT/434 7.7/7.8 – 4 mm allen key for ZAT440-FT/444 7.8/7.9 – wire cutter for ZAT460-FT/464 9.7/10.5 for ZAT470-FT/474 9.9/10.6 ø 9 – 14 mm 1 –...
-
Page 4: Maintenance
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out Warning: Do not open luminaire while mains supply is switched on. -
Page 5: Installation
Installation The product must be installed and maintained by a building/construction and/or electrical regulations and relevant legislation. Warning: Switch off mains electrical supply prior to installing and connecting the luminaire. Notice: than the original manufacturer, then the warranty will no longer be valid and shall become the full respon- sibility of the modifying person/organisation. -
Page 6: Installation Procedure
Installation Procedure 1) Switch off mains electrical supply. 2) Check that rating shown on luminaire label conforms with mains electrical supply. 09/19 IP66 ZFT444 220-240V/50 Hz, 1-10 115-XXXX SOE XXXXXXX LED 4000K 18W item no. XXX (example) 3) Feed mains cable A into column B, while 4) Trim mains cable A to the desired length and setting luminaire in position by following the connect the leads to their respective terminals... - Page 7 WE-EF HELVETICA WE-EF LIGHTING Switzerland United States of America Tel +41 22 752 49 94 Tel +1 724 742 0030 Fax +41 22 752 49 74 Fax +1 724 742 0035 info.switzerland@we-ef.com info.usa@we-ef.com TO9265W0221 © WE-EF 2021 subject to change.