Welcome to Platinum Series 3G Register your Platinum In-Wall 3G speaker Register your speakers using the QR code Thank you for purchasing this Platinum Series 3G speaker, or visit monitoraudio.com/registration you’re now ready to start your journey to breathtaking sound.
Unboxing Before you unpack your speakers, please make sure that there is plenty of available floor space. WARNING: DO NOT attempt to lift the speaker alone. The recommended number of people is printed on the outer carton. Lay the box down on the floor so the opening is facing up. Open the outer carton and then use the handles of the inner cardboard sleeve to lift the speaker and packaging out of the box.
Page 4
Transducer and mid-range assembly rotation The Platinum In-Wall 3G has the ability to be positioned in a left/right vertical or horizontal centre channel configuration. To position the Platinum In-wall 3G in a horizontal centre channel position, rotate the ‘mid-pod’ that houses the MPD transducer and mid-range assembly.
Setting up your system 2-channel system When arranging a 2-channel system, the listening position and the speakers should form an equilateral triangle. The speakers should be positioned approximately 1.8 - 3m (6 - 10’) apart. They should be positioned so that the transducer is at approximate ear height when you are in your listening position.
Page 6
Setting up your system AV positioning Please refer to the illustration on the right for the ideal angles and positions of each speaker in your surround system. If setting up a 5.1 system you should place your surrounds in position (A). If setting up a 7.1 surround system you should place your side speakers in position (B) and rear speakers in position (C) to create a full 360°...
Page 7
Setting up your system Dolby Atmos ® When arranging the overhead channels in a Dolby Atmos system, we would ® recommend using our three-way in-ceiling speakers such as our Platinum PLIC II speakers. These employ a unique midrange / tweeter module, which offers a wider dispersion characteristic, and are ideal for Dolby Atmos duties.
Page 8
The Platinum In-Wall 3G has one set of terminals for single wiring. Single wiring is The Platinum In-Wall 3G comes with a pair of switches to adjust the mid and high achieved by using a single set of cables to the binding posts on the side of the speaker.
Using your speakers Running-in your speakers Run your speakers in by playing normal music at low-mid listening levels for approximately 50-70 hours play time. You may find the sound will continue to improve even after the 70 hour mark. This can be done naturally over time: like a fine wine the performance will improve with age.
In the unlikely event that there is a defect with this product, it is covered by Model Platinum In-Wall 3G the Monitor Audio manufacturer’s warranty, provided that the product was System Format 3-way supplied by an authorised Monitor Audio retailer.
Need help?
Do you have a question about the Platinum In-Wall 3G and is the answer not in the manual?
Questions and answers