Controls - GE Zoneline AZ45 Owner's Manual

Controls

Temp Control
the room at the same level of comfort.
Press the + pad to raise the temperature.
Press the - pad to lower the temperature.
NOTE:
room temperature.
Fan, Mode and Operation Control
FAN—Sets the fan operation for HIGH or LOW.
MODE— COOL—For cooling
FAN—For fan-only operation
HEAT—For heating
OFF—
Sentinel features still function if active. See the
USE WALL THERMOSTAT—
when the unit is controlled by a wall thermostat. See
Quick Heat Recovery
Activates each time the thermostat is switched from OFF
or COOL mode to HEAT mode, on heat pump models.
Electric heaters are energized until the thermostat set
About Your Heat Pump
Heat pumps can save money by capturing heat from the
outside air—even when the outside temperature is below
freezing—and releasing that heat indoors.
pump, don't change the room thermostat by more
than one degree at one time. Raising the heat setting
heating elements in order to reach the new temperature
setting quickly.
heat pumps and cost more to operate.
6
(AZ65 only)
Control Lock Out
from changing the operation mode of the unit.
While the unit is in the desired operating mode, press
seconds to lock the control and the desired setting. Any
temperature that was locked to flash 5 times and then go
dormant.
and resume normal operation.
NOTE:
control panel is locked.
NOTE: When switching between modes, it may take
several minutes to completely change operation.
any setting to prevent short cycling.
compressor cycles off.
When the outdoor temperature is lower than 25°F, heat
is provided by the electric heater instead of by the heat
pump.
When the outdoor temperature is lower than 35°F,
cooling operation is locked out to prevent damage to the
compressor. Operation will resume when the outdoor
display will flash if the
49-5000355 Rev. 6