Controls; Remote Control - GE AWGH18WWF Owner's Manual & Installation Instructions

Controls

Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
1 2 3
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the set temp.
2. Display
Shows the room temperature in Fan mode. Shows the
Set temperature while setting the temperature in Cool,
ECO or Heat modes.
3. Temp and Delay Increase (+) /Decrease (–) pads
be set in Cool, ECO or Heat mode.
4. Mode Pad
Heat mode.
5. Fan Speed Pad
In Cool, ECO or Heat
to Auto, High, Med or Low on the unit.
In Fan
or Low on the unit.
6. Delay (set by remote control only)
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay pad. Each touch of the Increase
+ –
/ Decrease pads will set the timer in 1-hour
intervals.
To review the remaining time on the Delay timer,
press the Delay
–
Decrease pads to set a new time if desired.
To cancel the timer, press Decrease
the set time is "--".
7. Sleep Pad (set by air conditioner controls only)
The Sleep mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
49-5000855 Rev. 0
4 8
Filter
Mode
Cool Fan Eco Heat
Reset
Speed Auto Low Med High
5
Cool, Fan, Eco or
High, Med,
+
Increase /
-
pad until
7
Sleep
Mode
The Sleep mode is available only in Cool, Heat and
Fan only settings.
Press the Sleep mode pad and its light will
illuminate. The fan indicator will stay at the same
setting but the air conditioner will automatically
change the Fan speed to low in either Cool, Heat or
Fan only mode.
In Fan only mode, the fan will stay in the Low speed
setting for 8 hours.
will resume the settings that were in place before the
SLEEP mode button was pressed.
In Cool mode, the fan will stay in the Low speed
setting for 8 hours from the time the Sleep mode
pad was pressed. The air conditioner will also
raise the set point 2°F in 30 minutes and 2°F more
in another 30 minutes where it will remain for the
next 7 hours. After 8 hours, the air conditioner will
resume the settings that were in place before the
SLEEP mode button was pressed.
In Heat mode, the fan will stay in the Low speed
setting for 8 hours from the time the Sleep mode
pad was pressed. The air conditioner will also
lower the set point 2°F in 30 minutes and 2°F more
in another 30 minutes where it will remain for the
next 7 hours.After 8 hours, the air conditioner will
resume the settings that were in place before the
SLEEP mode button was pressed.
While the unit is in SLEEP mode, pressing any pad,
the unit will exit SLEEP mode.
8. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
250 hours of operation. Clean the air filter (refer to
page 7), place it back in the front panel, and press the
Filter Reset pad. The light will go off.
9 . WiFi Connect Pad
Enables connection of the air conditioner to the
home WiFi. Download App for details at:
GEAppliances.com/connect.
1
Power
5
Speed
4
Mode
Eco Delay

Remote Control

After 8 hours, the air conditioner
3
6
5