Table of Contents
Advertisement
• Do not use any of the following words for the name of a volume as these words are reserved for internal use by
the TeraStation: array x, authtest, disk x, global, homes, info, lost+found, lp, mediacartridge x, msdfs_root, mt-
daapd, printers, ram, spool, usbdisk x. Any instances of "x" denote a number (for example: array1 or disk2)
1
In Settings, click Drives.
2
If you want to specify a volume size or change it later, enable LVM by referring to the "Size Limits" section
above. LVM does not need to be enabled for a drive or array to be used as an iSCSI hard drive, as you can still
create an iSCSI volume from the entire drive or array. However, enabling LVM is recommended for drives or
arrays that will be used for iSCSI.
To use the whole drive or array as an iSCSI hard drive, proceed to the next step.
3
Move the iSCSI switch to the
4
Click
to the right of "iSCSI".
5
Click Create Volume.
6
Enter a volume name, volume description, drive or array where a volume will be created, and volume size (if
you enabled LVM). Click OK when finished.
position to enable iSCSI.
57
Advertisement
Table of Contents
