Table of Contents
Advertisement
LCD Message
Cartridgex I36
Decryption error
Recovery I37
SystemRecovering
Recovery I38
RecoveryFinished
Recovery I39
Change Boot
Recovery I40
DataWillDeleted
Recovery I41
PushFuncToStart
Recovery I42
Preparing
Recovery I43
Unsupported HW
Recovery I44
Disk1 not found
Recovery I45
Recovery Failed
RAID ARRAY I46
RMM+Processing
SYSTEM I47
Don't Power Off
FailOver I48
PushFuncToStart
FailOver I49
LostMainTarget
FailOver I50
Maintenance mode
FailOver I51
Initializing
New Firmware I52
Available
BackupTask xx I54
Backup Failure
Description
The media cartridge cannot be decrypted.
The media cartridge may have been
encrypted by a TeraStation other than this
product.
System recovery in progress.
System recovery is complete.
System recovery from the USB recovery
device is complete.
Beginning recovery. All data on the drive
will be deleted.
Press the function button on the front to
start the recovery process.
Preparing to start the recovery process.
The TeraStation was started from the USB
recovery device, but the system cannot be
recovered from this USB recovery device.
Recovery from the USB recovery device
was initiated, but drive 1 was not detected.
Recovery failed.
Data migration or conversion (RAID
migration) is in progress.
This TeraStation is ready to become the
failover backup for the main TeraStation.
The main TeraStation in the failover
configuration cannot be found.
Failover maintenance is in progress.
Initializing the failover configuration.
A new firmware version has been released.
The xxth backup job failed.
Corrective Action
Connect the drive to the TeraStation that
performs encryption to decrypt the drive.
-
-
Change the boot mode switch on the rear
to "HDD".
-
-
-
-
Make sure that drive 1 is present and fully
inserted in its slot.
-
Do not turn off the TeraStation's power.
Press and hold the function button on the
front of the target TeraStation until it stops
beeping to accept failover backup status.
Make sure that the main TeraStation is on,
working, and connected to the network.
Do not turn off the TeraStation's power.
Do not turn off the TeraStation's power.
Update the firmware.
Make sure that the backup job is
configured correctly. Make sure that the
NAS is on and not in standby mode. If the
backup job still fails, check the status of
NAS, network, and backup source and
destinations.
234
Advertisement
Table of Contents
