WaveRider NCL1135 User Manual page 52

Chapter 5 Deploying the NCL1135
5. Using the information from Radio PER, align the antenna at the NCL1135 Station so
that the number of packets missed is at a minimum rate.
6. When done with the antenna alignment, press any key to stop the Radio PER display,
then type <radio rxTest stop> to stop the test.
NOTE: When the Continuous Receive test is stopped, the Master
The information received from Radio PER during the Continuous Receive test will be similar to
the following output. The following output is from a Station (unit ID 2) communicating with the
Master (unit ID 1) that is also transmitting to another Station (unit ID 3).
station> radio rxtest start
Continuous Rx test started
Unit Id Link Status
--------- -----------
1 UP
broadcast
3 UP
Unit Id Link Status
--------- -----------
1 UP
broadcast
3 UP
Unit Id Link Status
--------- -----------
1 UP
broadcast
3 UP
Unit Id Link Status
--------- -----------
1 UP
broadcast
3 UP
Unit Id Link Status
--------- -----------
1 UP
broadcast
3 UP
[Radio Rx Test On]
station> radio rxtest stop
station>
38
NCL1135 statistics, both direct and broadcast, remain in the
Radio PER list and continue to be updated. If the Continuous
Receive test is restarted, the statistics for the Master and
broadcast will continue from where they left off. The Stations will
start from zero again.
Total # Received
----------------
1
509
1
Total # Received
----------------
1
510
1
Total # Received
----------------
1
512
1
Total # Received
----------------
1
515
1
Total # Received
----------------
1
518
1
Total # Missed PER (%)
-------------- -------
0 0
0 0
0 0
Total # Missed PER (%)
-------------- -------
0 0
0 0
0 0
Total # Missed PER (%)
-------------- -------
0 0
0 0
0 0
Total # Missed PER (%)
-------------- -------
0 0
0 0
0 0
Total # Missed PER (%)
-------------- -------
0 0
0 0
0 0
APCD–NC003–1.0