WaveRider NCL1135 User Manual page 38

Chapter 3 Configuring the NCL1135
The following example session shows how to configure Station B in
network. To configure the remaining Stations, use the same procedure, replacing the unit ID
and IP address for each with the appropriate information for that Station.
NCL1135>
NCL1135> radio channel 1
Radio channel changed to: 1
NCL1135> radio unitid 101
Unit ID changed to: 101
NCL1135> radio type station
Radio type changed to: Station
NCL1135> radio masterid 1001
Master Id changed to: 1001
NCL1135> ip address ethernet 10.0.2.101 16
IP addresses:
Ethernet: 10.0.2.101/16
NCL1135> mode bridging
Forwarding mode: Bridging
NCL1135> radio
RADIO CONFIGURATION:
Radio type
Wireless ID
Speed
Channel
Regulatory Domain : FCC/IC
Frequency
Interframe spacing: 32 (281.6 micro seconds)
Hardware address
Network Card IRQ
NIC Base Address
Master ID
NCL1135> ip
Forwarding Mode: BRIDGING
Addresses:
Ethernet: 10.0.2.101/16
Routing: IP Routing (Static Only)
Routing Table:
Destination
--------------------------------------------------------------------
10.0.0.0
10.0.2.101
127.0.0.1
--------------------------------------------------------------------
DNS Domain Name:
DNS Servers:
No DNS servers defined.
NCL1135> write
24
: Station
: 101
: 11Mbs
: 1
: 2.412 GHz
: 00:90:27:CA:62:A3
: 5
: 0x0d0000
: 1001
Mask Gateway Flags
16 10.0.2.101 UC
0 10.0.2.101 UHL
0 127.0.0.1 UH
Figure 10
Sets the NCL1135 type to Station
Identifies the unit ID of the Master for
this Station
Protocol Interface
Local eeE0
ICMP lo0
Local lo0
to join the
APCD–NC003–1.0