Configuring The Ncl1135; Setting The Radio Configuration - WaveRider NCL1135 User Manual

Table of Contents

Advertisement

Chapter 3 Configuring the NCL1135
3.2

Configuring the NCL1135

The procedures to configure the NCL1135 using a command-line interface are broken into two
main sections:
Radio configuration — see
IP configuration — see
To configure an NCL1135 correctly, you must complete both the radio and IP configuration
procedures.
You can also configure the NCL1135 with the following functionality:
DHCP Relay — see
SNMP — see
DNS Resolver — see

3.2.1 Setting the Radio Configuration

Before setting the radio configuration parameters, ensure that the NCL1135 has been
connected to a terminal and initialized as described in
NCL1135
, on page 12 and you have changed the password as described in
NCL1135 Password
Antennas and associated transmission cable must be installed
by qualified personnel. Failure to terminate the antenna port
correctly can permanently damage the NCL1135. WaveRider
assumes no liability for failure to adhere to this recommendation
or to recognized general safety precautions.
1. Determine the radio channel for the network. See
frequencies.
2. At the NCL1135> prompt, type <radio channel channel > to set the radio
channel for the NCL1135 where channel is the number of the network radio channel
on which it will be operating.
3. Determine the unit IDs for the Master and Stations for this NCL1135 network group.
The unit ID is a unique number, from 1 to 16383, that is used to identify the NCL1135
within the network group.
4. At the NCL1135> prompt, type <radio unitid unit_id > to set the NCL1135 unit
ID.
5. Set the NCL1135 as a Master or Station. To set the NCL1135 as a Master, type
<radio type master>. To set the NCL1135 as a Station, type <radio type
station>.
16
Setting the Radio Configuration
Setting the IP Configuration
Setting the DHCP Relay Configuration
Setting the SNMP Configuration
Setting the DNS Resolver Configuration
, on page 14.
WARNING!
on page 16
on page 18
on page 19
on page 20
on page 21
Connecting and Initializing the
Changing the
Appendix C
for a list of operating
APCD–NC003–1.0

Advertisement

Table of Contents
loading

Table of Contents