Table of Contents
Advertisement
Chapter 2 Network Considerations
2.2
Bridging and Routing Network Configurations
2.2.1 Point-to-Multipoint Bridging Network
In a point-to-multipoint network configuration, all the NCL1135s in the network must be either
configured as bridges or routers, not a mix of both operational modes.
configuration of a typical point-to-multipoint bridging network.
Ethernet
Type:
Unit ID:
Radio Channel:
Mode:
IP Address
Master ID:
In
Figure
5, unit A is configured as the network master and units B, C, and D as stations. Units
B, C, and D unit IDs must be manually added to the Remote Station List for unit A. The Master
ID on each station is set to the unit ID for Unit A. If a unit is not in the Master Remote Station
List and does not have the Master ID set to the unit ID for unit A, it will not be able to join the
network.
8
Figure 5
Point-to-Multipoint Bridging Network Example
NCL1135
D
Station
103
1
Bridging
- Ethernet:
10.0.2.103
1001
Ethernet
NCL1135
Type:
Unit ID:
Radio Channel:
Mode:
IP Address
- Ethernet:
Remote Station List:
Type:
Unit ID:
Radio Channel:
Mode:
IP Address
Master ID:
Radio
A
Master
1001
1
Bridging
10.0.2.44
101
102
103
Type:
Unit ID:
Radio Channel:
Mode:
IP Address
Master ID:
Figure 5
shows the
Ethernet
NCL1135
B
Station
101
1
Bridging
- Ethernet:
10.0.2.101
1001
Ethernet
NCL1135
C
Station
102
1
Bridging
- Ethernet:
10.0.2.102
1001
APCD–NC003–1.0
Advertisement
Table of Contents
