Table of Contents
Advertisement
Chapter 3 Configuring the NCL1135
DNS Servers:
No DNS servers defined.
NCL1135> write
The following example session shows how to configure Station B in
routing network. To configure the remaining Stations, use the same procedure, replacing the
unit ID for each Station with the appropriate ID for that Station.
NCL1135>
NCL1135> ip address ethernet 11.0.2.101 16
IP addresses:
Ethernet: 11.0.2.101/16
Radio:
200, 10.0.2.44 p-t-p ?
ncl1135> dhcp mode relay
DHCP Relay Enabled
ncl1135> dhcp relay add 10.0.1.44
DHCP Servers/Relay Agents:
10.0.1.44
NCL1135> radio channel 1
NCL1135> mode routing
Forwarding mode: IP Routing
NCL1135> radio type station
Radio type changed to: Station
NCL1135> radio unitid 101
Unit ID changed to: 101
NCL1135> radio masterid 1001
Master Id changed to: 1001
NCL1135> ip address radio 1001 10.0.2.101 10.0.2.44
IP addresses:
Ethernet: 11.0.2.101/16
Radio:
1001, 10.0.2.101 p-t-p 10.0.2.44
NCL1135> ip route add 0.0.0.0 10.0.2.44 16
Routing Table:
Destination
--------------------------------------------------------------------
10.0.2.44
11.0.2.101
11.0.0.0
0.0.0.0
127.0.0.1
--------------------------------------------------------------------
NCL1135> radio
RADIO CONFIGURATION:
Radio type
Wireless ID
Speed
Channel
Regulatory Domain : FCC/IC
Frequency
Interframe spacing: 32 (281.6 micro seconds)
Hardware address
28
Mask Gateway
Flags
0
10.0.2.101
UHC
0
11.0.2.101
UHL
16
11.0.2.101
UC
0
10.0.2.44
UC
0
127.0.0.1
UH
: Station
: 101
: 11Mbs
: 4
: 2.412 GHz
: 00:90:27:CA:62:A3
Figure 11
Enable DHCP Relay
Add a DHCP Server to the DHCP
Relay table
Set the radio channel
Sets the radio IP
address for the route to
the Master NCL1135
Sets the default static route
Protocol
Interface
Local
mdr1
ICMP
lo0
Local
eeE0
Static
mdr1
Local
lo0
to join the
APCD–NC003–1.0
Advertisement
Table of Contents
