BRP EXOME User Manual page 11

B. THE HELMET
INSTALLING THE FACE SHIELD
1. Insert the upper tab of the face shield
into the specific location on the face
shield mechanism.
2. Once the tab is in position, pull the
lever of the face shield mechanism
downward and slightly push the lower
portion of the face shield to put back in
position the lower tab of the face shield.
3. Then, release the lever. Make sure
the spring put it back to the up position
and check if the visor is correctly in
place.
4. Repeat steps 1 - 3 for the other side.
For the other side, note that the face shield will be slightly tilted. Make sure
the lower tab of the face shield and the recess are perfectly aligned.
5. Once both sides are in position,
press the face shield pivots gently
towards
simultaneous closing movement.
6. Make sure that the face shield
mechanism is functioning properly
by closing and opening the face
shield to its maximum extent.
1
3
2
the helmet with a
10