Getting Started; Cabling Your Routefinder - Multitech RouteFinder RF825-C-Nx Quick Start Manual

Multi-tech routefinder rf825-c-nx security appliance: quick start

Hide thumbs Also See for RouteFinder RF825-C-Nx:

Table of Contents

Enlarged version

RouteFinder RF825 Series

Getting Started

This section of the Quick Start Guide covers cabling the RouteFinder,

setting up TCP/IP communications in order to connect to the Internet

through a wireless provider's service, activating a wireless account, and

connecting to the Internet. See the User Guide for detailed information on

the RouteFinder software program.

To use your RouteFinder, make the appropriate connections to PCs, a

cable or xDSL modem, an analog modem, and AC power. For AP models,

attach the antennas.

Turn the power off on all network devices (PCs, cable modems,

DSL modems, analog modems, and the RouteFinder).

Plug the RJ-45 cable into the Ethernet port on the PC and the

LAN port on the RouteFinder. (If you have more than one PC,

connect the others in the same way to the other LAN ports).

Connect the provided power supply cable to the 9 volt power port

on the back of the RouteFinder, and plug the other end of the

power supply into an AC power outlet as shown.

For the RF825-AP, attach the cellular antenna and the AP

antenna.

Note:

Be sure to locate this appliance where there is

wireless coverage.

Quick Start Guide

Table of Contents