Step 3 - Install The Modem Driver - Multitech MultiModem MT5634IND Quick Start Manual

Multi-Tech Systems, Inc. MT5634IND Quick Start Guide
Steps for Connecting Your Modem to Your System
RS-232 Connection
Plug one end of the serial cable into the RS-232 connector on the
modem, and plug the other end into a serial port connector on your
computer, such as COM1 or COM2.
Phone Line Connection
Plug one end of the phone cable into the MT5634IND LINE jack
and the other end into a phone line wall jack.
Power Connection
For AC
Plug the power supply cable with attached transformer block into
the power connector on the MultiModem. Then plug the AC cord
receptacle into the transformer block, and plug the other end of the
of the AC cord into a power outlet or power strip.
Note: Use only the power supply supplied with the MT5634IND.
Use of any other power supply will void the warranty and could
damage the modem.
For DC
Plug the fused cable into the power connector on the MultiModem.
Then attach the two wires at the other end of the fused cable to a
DC power source.
Step 3 – Install the Modem Driver
If you use Windows 98+, you must install the modem driver, which is
installed using the Windows Plug and Play feature. Follow the four-step
procedure below. If you use another operating system, see your
operating system manual.
1. Make sure your modem is connected properly, and then turn on
your computer. Windows should detect your new modem and
open the Install New Modem wizard.
2. Insert the MT5634IND CD, and then click OK.
3. Windows installs and configures the modem.
4. Click Finish to exit.
–
Note for Windows NT Windows NT inserts one additional prompt
before Step 2. Follow the on-screen directions and select the Multi-Tech
MT5634SMI-V92-IND driver.
6