Hardware/Software Confirmation - Multitech MultiModem MT2834ZDXI Quick Start Manual

the following command string to initialize your modem: AT&F<cr> . This setting
configures your modem to operate optimally with the software it is utilizing.
Note: Refer to your data comm software manual for more information on your
communications software.

Hardware/Software Confirmation

To confirm that your modem (hardware) and communications package (software) is
working properly:
1. Go into terminal mode in your data communications package.
2. To determine if your computer and modem are communicating properly, Enter:
AT<CR> At this point your video monitor should display OK.
3. To confirm your MultiModemZDX configuration, enter AT&V<cr> . The current
MultiModemZDX configuration is displayed, as shown in the following example.
AT&V
ACTIVE PROFILE:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0
&Y0
S00:002 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:030 S08:002
S09:006
S10:014 S11:255 S12:050 S18:000 S25:005 S26:001 S36:007 S37:000 S38:020
S46:138
S48:007 S95:000
STORED PROFILE 0:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0
S00:002 S02:043 S06:002 S07:030 S08:002 S09:006 S10:014 S11:095 S12:050
S18:000
S36:007 S37:000 S40:105 S41:003 S46:138 S95:000
STORED PROFILE 1:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0
S00:002 S02:043 S06:002 S07:030 S08:002 S09:006 S10:014 S11:095 S12:050
S18:000
S36:007 S37:000 S40:105 S41:003 S46:138 S95:000
TELEPHONE NUMBERS:
0 = 1 =
2 = 3 =
OK
Chapter 2 - Installation and Connection
13