Table of Contents
Advertisement
9.0 ZONE WALLPLATE OPERATION
1
Settings Button
Tap this to access zone wallplate settings ie: to adjust wall
plate colour theme and backlight settings.
2
Volume Slider
Touch and slide the volume of a chosen audio source up and
down as desired.
3
Volume +/- Buttons
Use these buttons to make fine adjustments to level control.
4
On/Off Selector
Switches an audio source or or off in the zone. Volume will
display at last used setting.
5
Output Zone Name
The name of the output zone.
6
Audio Source Name
The name of the audio source.
OPERATION
The zone wallplate or paging console connects to the controller via Cat5e UTP or similar cabling and can be located up to
200m away. Up to two plates (master or zone) can be connected on a single cable run, with a maximum of 8 wallplates
per system.
The zone wallplate allows for audio source selection and level control for the zone in which its located. This wallplate dis-
plays the status of the four audio sources and their respective volume levels.
To make changes, simply tap the volume +/- buttons or switch an audio source on or off using the on/off selector. When
an audio source is switched off, the controls will display in a darker colour.
To adjust the colour theme, tap the three lines icon on the top left of the screen. See section 13.0 for information on wall-
plate settings.
www.redbackaudio.com.au
Redback
A 4450 4 x 4 Audio Matrix/Switcher
®
(MATRIX MODE)
1
LOUNGE
DAB RADIO
2
Vol+
Vol
62%
Vol-
Vol
Off
7%
ROCK RADIO
3
Vol+
Vol
Vol
Vol-
55%
50%
4
On
Fig 4
Redback® Proudly Made In Australia
5
FOXTEL
Vol+
Vol-
Off
6
RADIO MIC
Vol+
Vol-
On
9
Advertisement
Table of Contents
