Master Wallplate Operation (Selector Mode) - Redback A 4450 Operating Manual

Redback A 4450 4 x 4 Audio Matrix/Switcher
®
10.0 MASTER WALLPLATE OPERATION
1
2
1 Settings Button
Tap this to access settings to adjust output zone / audio source names, colour themes and backlight settings.
2 Zone Selection Area
This area is used to toggle between the four output zones to adjust to source selection & level control.
3 Output Zone Name
The name of the output zone that sources are displayed for.
4 Input Selection Area
This area is used to select between the four audio sources in the chosen output zone.
5 Volume Slider
Touch and slide the volume of a chosen audio source up and down as desired.
6 Volume +/- Buttons
Use these buttons to make fine adjustments to level control.
7 Muting On/Off Selector
Switches an muting on or off for the chosen output zone. Volume will display at last used setting.
OPERATION
The master wallplate connects to the controller via Cat5e UTP or similar cabling and can be located up to 200m away. Up
to two plates (master or zone) can be connected on a single cable run, with a maximum of 8 wallplates per system.
The master wallplate allows for audio source selection and level control for every output zone. The left side of the screen
displays the output zones with the custom zone labels you have selected. Below the name, the status of the selected audio
source and volume level is displayed.
Note: In selector mode only one audio source can be selected at a time.
To make changes, tap the output zone you desire on the left. Then select an audio source and adjust the level using the
volume slider or volume +/- buttons. Muting can also be switched on and off.
10 Redback® Proudly Made In Australia
(SELECTOR MODE)
Zone Selection
DINING
FAMILY
DAB RADIO : 50% DAB RADIO 2 : 50%
KITCHEN PATIO
FOXTEL : 100%
MP3 PLAYER
Mute Active
DINING
Input Selection
DAB RADIO DAB RADIO 2
FOXTEL MP3 PLAYER
Volume Control
Vol+
Vol
Vol-
50%
Mute
OFF
Fig 5
3
4
5
6
7
www.redbackaudio.com.au