National Instruments 776572-00 User Manual page 120

Index
J
jumper settings
analog configuration
filter selection, 2-7 to 2-8
grounding, shielding, and output
mode selection, 2-6 to 2-7
jumper W1, 2-7
jumper W10, 2-6 to 2-7
jumpers W2 through W4, 2-7 to 2-8
jumpers W7 and W8, 2-8 to 2-9
output selection, 2-8 to 2-9
reference mode selection, 2-7
analog input channels, 2-13 to 2-16
analog output signal connections, 2-24
digital signal connections
illustration, 2-5
jumper W5, 2-3 to 2-4
jumper W9, 2-4
jumper W11, 2-4 to 2-5
fixed jumpers, 2-3
parts locator diagram, 2-2
temperature sensor of terminal block,
2-19 to 2-20
user-configurable jumpers, 2-3
L
LabVIEW software, 1-2
LabWindows software, 1-2
LOAD* bit, 4-8
M
MCH0 and MCH1 signal
analog output, 2-17, 2-24
analog output circuitry, 3-13 to 3-14
description of, 2-23, B-2
measurements. See scanning measurements;
single-channel measurements.
MISO signal
buffering to SERDATOUT pin, 2-3
description of, 3-5, C-3
equivalent to SERDATOUT signal, 3-6
MOD<3..0> bit, 4-9
Module ID Register
description of, 4-2
digital control circuitry, 3-8 to 3-9
reading from, 2-29
timing diagram, 2-29
MOSI signal
description of, 3-6, C-4
equivalent to SERDATIN signal, 3-6
MTEMP signal
analog output circuitry, 3-13
connecting to temperature sensor,
2-19 to 2-20
description of, 2-13, D-2
measuring voltage, 5-5
multiple-chassis scanning
programming considerations, 5-9 to 5-10
theory of operation, 3-16
multiple-module multiplexed scanning
programming considerations, 5-9
theory of operation, 3-15 to 3-16
multiplexer/input channel
correspondence, 3-11
MUXCOUNTER signal
analog input and timing circuits,
3-10 to 3-11
Index-4 © National Instruments Corporation