Dust Exhaust Adapter; Thermal Overload Protection; Replacement For Cutting Discs; Maintenance And Cleaning - Westfalia 49 43 85 Instruction Manual

Dust Exhaust Adapter

During operation, a considerable amount of dust will develop. Therefore we
recommend operating this machine with a dust extractor or vacuum cleaner.
Always wear a dust mask!
The machine is equipped with a universal dust exhaust adapter. Assemble the
dust exhaust adapter (8) on the exhaust channel so that it points away from the
machine in upper left direction.
Then loosen the cap (11) a little bit by turning it counter clockwise. Insert the
suction pipe of a vacuum cleaner or other dust extractor and fasten the cap until
the pipe is sufficiently fixed.

Thermal Overload Protection

This machine is equipped with an electronic overheat protection that will switch off
the machine automatically in case the motor becomes too hot. If that happens
during operation, please allow the machine to cool down for 30 minutes before
you continue working with it.

Replacement for Cutting Discs

Suitable spare cutting discs can be ordered from Westfalia (Article no. 53 51 79).
Cutting discs with following criteria are suitable:
 Type: segmented dry-cut diamond cutting disc
 Outer diameter: 125 mm
 Inner diameter: 22.2 mm
 Rated speed: 80 m/s or 13000 rpm

Maintenance and Cleaning

 Always disconnect the plug from the mains socket before carrying out any
work on the machine.
 Make sure the machine is always clean, dry and free of oil.
 Use a clean and dry cloth for cleaning. Do not use any strong or inflammable
cleaners such as petrol, paint thinner, turpentine or similar cleaning agents.
 Always keep air ventilation holes free of dust deposits to prevent overheating.
Operation
14