Advertisement
Check that the length and positioning of the support arms is
13
correct: insert one of the support arms into its wall socket. Drop
the 90° end into the glass boss and tighten the grub screw. Slide
the support arm in and out of its wall socket until the glass is
plumb vertical, then tighten the two socket grub screws fully. Fit
the second support arm in the same way.
Using the suction glass lifters, carefully re-insert the glass panel
15
into the floor profile; drop the support arms into the bosses, and
tighten the grub screws.
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road,
Dunmow, CM6 1XJ
Once you are satisfied that the support arms are located correctly,
14
loosen the glass boss grub screws and lift the support arms out. Lift
the glass panel from the floor profile using suction glass lifters, and set
to one side (leaving the support arms suspended from the wall).
Apply a bead of silicone along the inside of the floor profile, as shown.
Make sure all screws and fittings are tight. Apply a dab of silicone
16
to the screw covers and fit them over the boss Allen bolts.
Telephone + 44 (0) 8448 001 500
Facsimile + 44 (0) 1279 635 074
info@majesticshowers.com www.majesticshowers.com
Advertisement
