GE ecomagination Profibus DP AF-650 GP Instruction Manual page 5

1.2.3 Warning Against Unintended Start
1
1. The motor can be brought to a stop by means of digital commands, network commands, references or a local stop, while the adjustable frequency
drive is connected to line power. If personal safety considerations make it necessary to ensure that no unintended start occurs, these stop functions
are not sufficient.
2. While parameters are being changed, the motor may start. Consequently, the Off key on the keypad must always be activated; following which data
can be modified.
3. A motor that has been stopped may start if faults occur in the electronics of the adjustable frequency drive, or if a temporary overload or a fault in
the supply line power or the motor connection ceases.
1.2.4 Warning
Touching the electrical parts may be fatal - even after the equipment has been disconnected from line power.
Also make sure that other voltage inputs have been disconnected, such as an external 24V DC using option module OPC24VPS,, load sharing (linkage of DC
intermediate circuit), as well as the motor connection for kinetic backup.
Please refer to the AF-650 GP or AF-600 FP Drive Instruction Manual for further safety guidelines.
1.3 About this Manual
First time users can obtain the most essential information for quick installation and set-up in these chapters:
Introduction
How to Install
How to Configure the System
Application Examples
For more detailed information including the full range of set-up options and diagnostics tools please refer to the chapters:
How to Control the Adjustable Frequency Drive
How to Access the Parameters
Parameters
Troubleshooting
1.4 About PROFIBUS
PROFIBUS is standardized in the international standards IEC 61158 and IEC 61784, and supported by the member companies of the PROFIBUS International
user community.
PROFIBUS International (PI) is the umbrella organization for all Regional PROFIBUS Associations (RPA) worldwide. PI has engaged PNO (PROFIBUS Nutzerorgani-
sation, e. V.), Germany, a non-profit organization based in Karlsruhe, Germany, to establish technical committees and working groups in order to define and
maintain the open and vendor-independent PROFIBUS technology. Any member of PROFIBUS International may take an active part in maintenance and further
development of the PROFIBUS technology. This guarantees openness and vendor independence of the PROFIBUS technology.
For access to the vast quantity of PROFIBUS literature including information and downloads for PROFIBUS DP and the PROFIdrive profile, please refer to
www.profibus.com.
1-2
AF-650 GP/AF-600 FP Profibus DP Instruction Manual
DET-624