Audible Alarm; Wiring - BD Diesel Performance Monitor Cool Engine Shutdown Installation Instructions Manual

5/11/2006 1081100 Cool Engine Shutdown Page 6
shutdown the engine. This was implemented to protect the vehicle from being stolen
when the engine is in cool down mode; eventually the brake pedal would have to be
pressed which will shutdown the engine preventing the thief from easily driving away
with the vehicle. This is also useful in situations where the engine needs to be
shutdown immediately or is desired to be shutdown sooner.

Audible Alarm

As an added bonus to the engine shutdown function of the CES, there is an audible
alarm built into the module. While monitoring the data between the X Monitor
controller and display for the exhaust temperature, the CES also is looking for any
registered alarms flashing on the display. When the alarm is flashing, the CES module
will emit a repeating tone that will stop when the alarm stops flashing on the display.
There are three volume settings for the audible alarm: high (default), low and off.
The volume of the audible alarm is can be adjusted by a jumper setting inside the
module. To do this, with the communication cables and the 5-terminal connector
unplugged, remove the screw on the back of the module and take the top cover off. In
the upper left section of the board, near the display communication connector, there is
a 3-pin connector with a jumper.
For high and low volume the jumper will connect the center pin and one the two (2)
outer pins marked "HI" and "LO". For no alarm, place the terminal on either one of the
outer pins and away from the center pin.

Wiring

Disconnect the communication cable from the X Monitor controller that leads to the
display and insert into the port marked "Display" on the CES module. Utilizing the 18"
communications cable supplied with the CES module, plug one end into the port
marked "Controller" on the CES module and the other end into the display port on the
X Monitor controller.
Using the following charts, tap onto the vehicles wires using the appropriate sized
Posi-Tap connector (not necessary if soldering the connections). All the vehicle wires
are located under the dash.
BD Engine Brake Inc.
Plant Address: Unit A10, 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295 U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
Phone: 604-853-6096 Fax: 604-853-8749 Internet: www.bd-power.com