Ten-Haaft Oyster Connect Operating Instructions Manual page 18

5. OPTIONAL SETTINGS
System Options
Additional public DNS: [OFF / ON]
(Additional public Dynamic Name Server)
When this setting is [ON], the Oyster® Connect uses an additional, publicly accessible directory server for web-
sites (DNS). However, problems may then occur when calling up the login web page of open
fore, the default setting is [OFF]. Changes to the drop-down menu are saved automatically.
Time Zone Setup
Here you can set the time zone according to your current location. Currently, however, the setting has no prac-
tical effect on the operation of the Oyster® Connect.
Website Password Protection:
In the [Standard] state, access to the [Start Page] is possible without entering a user name and password. In the
[Enhanced] setting, a login is also required for the [Start Page].
The login data is always the same as for the [Indoor WLAN Setup] or [System Setup] pages.
Change Login Password (optional)
The Oyster® Connect website can be partially or completely password-protected. The non-changeable user name
is always "oyster", the default password is "connect". If you are the sole user of the Oyster® Connect, then you
do not necessarily have to change the password, because the website is only accessible to participants who have
already deliberately included it in the Oyster® Connect network. If you use the Oyster® Connect together with
people you do not know, for example in a coach or a rented motorhome, it is of course advisable to change the
default password. You can easily change the password here: enter the desired new password twice in succession
in the fields "New Password" and "Repeat Password" and press the button
you will be asked for the new password.
Note:
Please refrain from using the following special characters when assigning the new password: % = ? \
34
WLAN. There-
[Standard / Enhanced]
Change
. The next time you log in,
5. OPTIONAL SETTINGS
System Shutdown
(Shut down system)
With this button you can shut down and switch off the Oyster® Connect directly from the website. To switch the
Oyster® Connect on again, press the ON/OFF button (1) on the Indoor Unit.
System Reboot
(System Restart)
With this button you can trigger a restart of the Oyster® Connect from the website. The WLAN of the Oyster®
Connect will then be unavailable for about 2 minutes. Please make sure that your smartphone / tablet / laptop
etc. has not automatically connected to another WLAN in the meantime.
Thermal Info
(Temperature Information)
The following data from the system is displayed here:
CPU temp (°C):
This is the core temperature of the main processor of the Oyster® Connect. At normal room temperature and with
good ventilation, this usually settles between 45°C and 65°C.
If the Oyster® Connect is operated in an exceptionally warm environment, e.g. in a heated interior without
ventilation, the CPU temperature will inevitably rise. At around 100°C, the Oyster® Connect switches off auto-
matically and goes into protection mode. To restart it after cooling down, the Oyster® Connect must be briefly
disconnected from the power supply.
CPU freq:
This is the internal clock frequency of the main processor in megahertz (MHz). Normally, this always remains
stable at 816 MHz, unless the CPU temperature rises very high. Then the clock frequency is gradually reduced to
reduce heat development, which may be reflected in a somewhat slower response time of the Oyster® Connect.
LTE temp (°C)
This is the internal temperature of the LTE module in the outdoor unit.
At room temperature, this is usually in the range between 35 and 40°C. With strong sunlight and high outdoor
temperatures, values of up to 90°C can be reached, but this is not yet a problem for the technology.
35