Ten-Haaft Oyster Connect Operating Instructions Manual page 17

5. OPTIONAL SETTINGS
Numerous settings can be made on this web page, which are explained in detail here:
Software update options:
Check Update
Checks the availability of an Oyster® Connect software update.
Start Update Now
Starts the download of the software and the update process.
Please allow approx. 10 minutes for the system to complete the update and then restart automatically.
LTE Options:
Explanation LTE Only Mode (ON / OFF)
The Oyster® Connect can dial into 2G, 3G as well as LTE networks. Nowadays, however, the 2G network is in
most cases only used for SMS and voice telephony, which is why using the 2G network for a data router like the
Oyster® Connect usually does not make sense.
The Oyster® Connect always works automatically with the fastest connection (LTE > 3G > 2G).
In very unfavourable reception locations, however, there may be a strong 2G signal but only a very weak 3G / LTE
signal. If the Oyster® Connect should switch to the 2G network, e.g. while driving, in the absence of a 3G / LTE
signal, the activated "LTE Only Mode" prevents an unnecessarily long "sticking" to the 2G signal.
LTE Only Mode: [ON]
The LTE connection setup is triggered again approx. every 60 seconds until an LTE (or at least 3G) connection
can be re-established re-established. Until then, LED1 flashes red, even if a 2G signal would be present. The 2G
network is therefore ignored.
LTE Only Mode: [OFF]
The Oyster® Connect logs into LTE and 3G as well as 2G networks. In 2G networks, however, data transmission
may be severely restricted.
32
5. OPTIONAL SETTINGS
LTE PIN reset with PUK (if SIM card is locked):
After three incorrect PIN entries, a SIM card is temporarily locked (LED5: fast red flashing). To unblock it, you
need the 8-digit PUK, which is usually supplied together with the PIN by the mobile phone provider. Sometimes
the PUK is also called the "super PIN".
1) Enter the PUK in the [Enter PUK] field.
2) Enter the PIN in the [Enter PIN] field.
3) Press the [Send] button
4) Select the [Start Page] tab at the top of the navigation bar.
5) Press the [LTE Mode] button on the start page.
Note:
You have a maximum of 10 attempts to unblock the SIM card using the PUK. After 10 incorrect PUK entries,
the SIM card will be permanently blocked.
SIM Card PIN security [ON / OFF]
For SIM cards that were delivered with a PIN and a PUK number, the PIN query is usually activated. To use the
card, you must know the PIN.
You can deactivate the PIN query by selecting [PIN security OFF]. Provided you know the current PIN.
With the selection [PIN security ON] you can activate the PIN request, provided that a PIN exists for this SIM
card. If the SIM card was originally delivered without PIN & PUK, the PIN request cannot be activated either.
Please select the desired state, enter the correct PIN in the [Enter PIN] field for authentication and then press the
Save
button. The change will take effect the next time you restart Oyster® Connect.
Outdoor WLAN Options
Delete all Outdoor WLAN passwords (after reboot)
The Oyster® Connect saves the passwords of all outdoor WLANs to which you have already connected the system.
Delete
If you wish, you can use the button to delete all saved passwords from the memory. The change is
only visible on the start page after the next restart of the Oyster® Connect.
Delete
33