Ten-Haaft Oyster Connect Operating Instructions Manual page 15

Hide thumbs Also See for Oyster Connect:

Table of Contents

5. OPTIONAL SETTINGS

Activate

Restart Indoor WLAN with new Settings:

(Restart of the Indoor WLAN with new settings:)

All changes in the settings of the Indoor WLAN setup only take effect when the button

pressed. The Indoor WLAN of the Oyster® Connect is then not available for a few seconds. It is therefore

advisable to make all planned changes on the website first and only restart the connections once with the

Activate

button

at the end.

Note:

While the indoor WLAN of the Oyster® Connect is restarting, your device (smartphone, tablet, laptop, etc.) may

automatically switch to another, known WLAN in the vicinity.

You will then have to select the tH2-.... or tH5-.... WLAN of the Oyster® Connect again in order to continue to

be connected to the Oyster® Connect.

Show IP of all connected network devices:

(Display of the IP addresses of all devices present in the network).

Check

After pressing the button,

all IP addresses assigned by the Oyster® Connect are listed. This

allows you to draw conclusions about how many devices are currently connected to the Oyster® Connect.

Select Indoor WLAN Mode:

(Select Indoor WLAN Mode:)

2.4 GHz fast mode The tH5-... WLAN is deactivated, the tH2-... WLAN becomes faster.

5 GHz fast mode The tH2-... WLAN is deactivated, the tH5-... WLAN becomes faster.

Dualband Mode Both indoor WLANs of the Oyster® Connect are in operation (default)

ALL WLAN OFF - All WLANs are switched off, access is only possible via LAN.

If you have changed the setting, it must be saved with the button

effective after the button

Activate

has been pressed.

Activate

Check

Set

next to it. The change only becomes

Table of Contents