Declaration Of Conformity; Regulatory Information - General Instrument SURFboard SB3100 User Manual

REGULATORY INFORMATION

Federal Communications Commission Radio and Television Interface Statement for
a Class 'B' Device.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in the residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If the equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
Increase the separation between the equipment and the effected receiver
Connect the equipment on a circuit different from the one the receiver is on
You may find the following booklet, prepared by the Federal Communication
Commission, helpful:
How to Identify and Resolve Radio-TV Interference Problems
Stock No. 004-000-0342-4,
U.S. Government Printing Office
Washington, DC 20402
Changes or modification not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This product was FCC certified under test conditions that included the
use of the supplied cable between system components. To be in
compliance with FCC regulation, the user must use this cable and install it
properly.

Declaration of Conformity

According to 47CFR, Parts 2 and 15 for Class B Personal Computers and
Peripherals; and/or CPU Boards and Power Supplies used with Class B Personal
Computers, General Instrument, 6450 Sequence Drive, San Diego, CA 92121,
declares under sole responsibility that the product identifies with 47CFR Part 2 and
15 of the FCC Rules as a Class B digital device. Each product marketed is identical
to the representative unit tested and founded to be compliant with the standards.
Records maintained continue to reflect the equipment being produced can be
expected to be within the variation accepted, due to quantity production and
testing on a statistical basis as required by 47CFR 2.909. Operation is subject to
the following condition: This device must accept any interference received,
including interference that may cause undesired operation. The above named party
is responsible for ensuring that the equipment complies with the standards of
47CFR, Paragraph 15.101 to 15.109. The Class B digital apparatus meets all
requirements of the Canadian Interface Causing Equipment Regulations.