Toro 31952 Installation Instructions Manual page 5

Installing the Decal
1. Install the decal on the machine as shown in
Figure 7.
1. Decal
2. Install the front left tire, torque the lug nuts, and
lower the machine. Refer to Installing the Front
Tires in the Operator's Manual.
Figure 7
Calibrating the Sensor
1. While on a flat surface, remove the plug from
the calibration connectors
g307045
1. Calibration connectors
2. Plug the calibration connectors together as
shown in
3. Turn the ignition key to the O
not start the engine.
4. The displays shows Slope Sensor Calibrating.
Note:
The LED light next to the display screen
(Figure 9) is solid green as the sensor calibrates.
5
(Figure
Figure 8
2. Plug
Figure 8.
position, but do
N
8).
g307046
g315596