Table 2:
Hardware Connections
WPS
USB
Reset
18
18
Version 4.2.7.2, 05/2014. Copyright
Version 4.2.7.2, 05/2014. Copyright
Press this button to begin the WiFi Protected Setup
(WPS) Push-Button Configuration (PBC) procedure.
Press the PBC button on your wireless clients in the
coverage area within two minutes to enable them to join
the wireless network.
See
WPS
on page
70
The CGNV provides two USB 2.0 host ports, one on the
front of the device and one on the rear, allowing you to
plug in USB flash disks for mounting and sharing
through the LAN interfaces via the Samba protocol
(network neighborhood).
The CGNV supports the following Windows file systems:
FAT16
FAT32
NTFS
USB devices must not drain more than 500mA
from the USB port. USB devices requiring
more than 500mA should be provided with
their own power source(s).
Use this button to reboot or reset your CGNV.
Press the button and hold it for less than five seconds
to reboot the CGNV. The CGNV restarts, using your
existing settings.
Press the button and hold it for more than five
seconds to delete all user-configured settings and
restart the CGNV using its factory default settings.
See
Resetting the CGNV
information on resetting the CGNV.
NOTE:
Unless you previously backed-up the CGNV's
configuration settings prior to resetting the
CGNV, the settings cannot be recovered.
Hitron CGNV User's Guide
for more information.
on page
26
for more
2012 Hitron Technologies
2014 Hitron Technologies
INTRODUCTION