The Dct6208 Back Panel - Motorola dct6208 Reference Manual

The DCT6208 Back Panel

The rear panel of the DCT6208 consists of three types of interfaces - audio, video and data. The
table following this drawing describes each connection and its use.
1 2
Key
1 TO TV/VCR
2 CABLE IN
3 ETHERNET
4 AUDIO IN R
AUDIO IN L
5 SPDIF
6 VIDEO IN
VIDEO OUT
7 OUTLET
8 IR
9 USB
10 DVI-D
11 AUDIO OUT R
AUDIO OUT L
4
3
8 9 10
Description
This coaxial output connector is used to connect the DCT6208 to a TV or VCR operating
on channel 3 or 4.
The CABLE IN connector receives the incoming signal from your cable service provider.
Not currently enabled - intended for future use.
These connectors are used to connect a set-top between a peripheral audio device such
as a CD player and a stereo tuner or A/V receiver. In the current DCT6208 release, the
audio from the peripheral device will pass through the DCT6208 when it is turned off.
The orange coaxial SPDIF connector is a digital output connection that carries Dolby
Digital 5.1 audio or PCM audio.
It is used to connect the DCT6208 to a stereo tuner or A/V receiver to provide surround-
sound, theater-style audio.
The VIDEO IN connector accepts a baseband video input from a VCR, camcorder or other
video device. (Not currently enabled.)
The VIDEO OUT connector is used to deliver baseband video to an external device such
as a VCR or TV.
This AC outlet may be used to plug your TV into the DCT6208 as a convenient additional
outlet.
This connector enables the DCT6208 to control a VCR while recording a selected program.
Not all electronic program guides support this feature.
Not currently enabled - intended for future use.
Digital Video Interface. To connect high definition monitor or high definition television.
The RCA phono-type connectors are used to deliver audio to a stereo receiver.
TV Guide Interactive
4 5 6
11 12 13 14 15 16
® SM
. We Make TV Better
7
17
REV3-16.11.19.03